Maintenance Tips

Here are some Maintenance tips from our Gainesville, GA Appliance Repair Technician experts: 

For any air conditioner or appliance repair needs give us a call for SAME DAY repair services. 

Call us Today: (678) 648-7567
We are located at: 1 Southeast 1st Avenue Gainesville, FL 32601

Refrigerator Maintenance Tips

Practicing refrigerator maintenance allows you to keep your refrigerator running at maximum efficiency fo as long as possible. That means that you can put of buying a new fridge and your stored groceries will remain fresh longer. A little prevention can go a long way to increase your unit’s efficiency. 

Don’t keep your refrigerator’s temperature setting too low. If the temperature is too low, it will have to run more to cool to a lower temperature. You will end up paying way more than you should to keep your food fresh. 

Replacing the water filer is the easiest refrigerator maintenance tasks, do this every 6 months. If you don’t replace your fridge’s water filter this will result in clogged dirt and bacteria. It will not only decrease your fridge’s efficiency, but also lead to you drinking infected water. 

Keep your refrigerator’s condenser coils clean. 

The coils become dusty fairly quickly. If the coils are covered with debris, this will cut down on the refrigerators operating efficiency. Dirty coils will cause the compressor to run hotter than it normally should. This will reduce your fridges life span, and your electric bill will become more costly. So clean your condenser coils every 3 months, they are usually located under or behind your unit. 

Don’t stand infront of your refrigerator with the door open. Each time you open your fridge, warm air enters and cold air escapes. Then your fridge has to work extra hard to get the warm air inside to cool. 

Also make sure to wash the refrigerator and freezer gaskets. The gaskets are located along the seal, they help keep the doors sealed shut, preventing cold air from escaping so that the fridge runs more efficiently. If these gaskets become dirty, or clogged then cold air can escape, thats why you should make sure they are not cracked and clean them ever so often. 

Washer Maintenance Tips

Make sure your washer is level. If its not it can cause your machine to vibrate strongly during the spin cycle because the unit is a heavy one. 

Don’t over load your washer.  If you fill your washing machine with more clothes than it can handle, it will cause it’s belt to slip or break, then you will need to replace it. So avoid that hassle and don’t overload your washer. 

Use the correct amount of detergent. 

Most new machines can’t handle too much detergent, they don’t know how to drain it properly and will end up with too many sudes in the washer. Keep in mind that more detergent doesn’t mean cleaner clothes. 

Clean the fabric softener dispenser. 

When using fabric softener, add the recommended amount then top it off with water because fabric softeners are waxy and can gum up in you washing machine. This trick prevents that from happening. 

Turn off the water to your washing machine when your not using it. 

If your going away for awhile, turn off water supply to washer. This will prevent water pressure strain on the hoses and leaks from occurring. 

Dryer Maintenance Tips

Your dryer vent pipe should be made of aluminum. The white vinyl duct that was common several years ago no longer meets most building codes, because if your dryer ignites it, a fire may start in your home.

Clean lint filter. 

Your lint filter should be cleaned out before every load you put in your dryer. If you lint filter gets clogged, the dryer will not dry properly, and will increase the amount of time to dry your clothes. Also make sure that the lint filter doesn’t has any rips or tears, if it does replace it. 

Do not overfill your dryer.

If you cram clothes in your dryer the air inside will not circulate properly and you clothes will take forever to dry. When you overfill your dryer it causes pressure on the motor and belt also. 


Stove / Oven Maintenance Tips

Cleaning your oven regularly is important. 

Once a month you should run your oven on the self-cleaning cycle. Also clean around the oven door and door seal area, because the self clean does not cover these areas. Make sure to create extra ventilation during self cleaning mode, because when its in that mode it tends to create a very unpleasant smell, thats all the food remains and grease melting off.  After your oven has cooled, take a wet cloth and remove the remains from inside oven. Then line your oven with foil once its clean, this will help the oven stay cleaner longer. 

Clean your cooktop regularly but correctly. You can clean any porcelain cooktop with a non-abrasive cleanser. But don’t pour the cleanser directly onto the cooktop. Instead, put some cleaner on a soft, damp rag, then wipe the surface.

Keep the Surface Burners Clean. 

Its sometimes better to replace your old drip pans than trying to clean them. Because drip pans are fairly cheap to replace. But you can use foil under the stove top, because this is where the worst mess forms from spills and daily use.

Dishwasher Maintenance Tips

You should clean and deodorize the interior of you dishwasher. You don’t necessary need to clean the interior if you use it regularly. But if it goes un used for a week or more than you can remove the bad odor and clean it by placing a cup of vinegar a run a cycle. 

Don’t pre rinse dishes before placing them inside the dishwasher. 

Scrape off food and empty liquids, then the dishwasher will do the rest. Modern dishwashers do a great job cleaning even heavily soiled dishes.
To save energy: Use energy saving cycles whenever possible and wash only full loads, because your dishwasher uses the same amount of water whether its half full or completely full. 

Dishwasher Water Temperature should be hot for best washing and drying results. The water has to be at least 120 degrees F. To make sure that the water entering your dishwasher is hot enough turn on hot water faucet nearest to your dishwasher several minutes to clear cool water from the pipes. Hold a meat thermometer in stream of water to check the temperature. If the temperature is below 120 F, have a qualified person raise the hot water heater thermostat. 

Random Posts

LOAD MORE